Universal Laser Systems VLS3.50 Betriebsanweisung PDF herunterladen (Seite 23)

Link to Table of Contents

User Guide

User Manual

If the laser machine was improperly shut down, the engraving table will home at start up. To have this •

feature turned o, check the ‘Disable Automatic Z-Homing.’ Disabling this feature can also be helpful when

troubleshooting Z-Axis problems.

If you would like the laser system to re-home before it engraves a job, select ‘Home XY Before Engraving.’•

Universal laser systems contains an Air Pressure detection switch. This feature is only present when you use Manual •

Air Assist. To enable this feature, check the DETECT AIR PRESSURE box. If sucient air pressure (1.5 psi) is not

present, then an error message is displayed. If you use Computer Controlled Air Assist, this feature is not present

because our laser system automatically detects if sucient air pressure is present.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 70 71

Keine Kommentare

Universal Laser Systems VLS3.50 Betriebsanweisung Seite 23