Universal Laser Systems Laser Platform M-300 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 50)

5-2 Using the Laser System Step-by-Step

Material Loading and Positioning

The next step is to load and position the wood on top of the

engraving table, inside the laser system. Open the top door

and position the piece of wood into the upper left corner of

the table, against the rulers, as the diagram indicates.

Make sure that the position of the wood matches the

position of your graphic on your computer screen.

Focusing

Place you material onto the engraving table. Visually make sure that the height of the material

will not interfere with the focus carriage when you move it directly over the material. Press the

Stop and the Down button at the same time and observe the focus carriage move to the default

(1”,1”) position in the engraving area. Place the Focus Tool on top of the material and up

against the FRONT of the Focus Carriage.

When you press the Up or Down Button and hold it, the Z-axis table will move slowly for about

½ inch and then automatically increase to full speed. If you release the button and press it

again, it will again start off slowly and then increase to full speed.

1) Focus Tool

2) Application Material

3) Focus Tool tilted (exaggerated)

4) Top of bevel

5) Focal Length

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 99 100

Keine Kommentare

Universal Laser Systems Laser Platform M-300 Anleitung zur Fehlerbehebung Seite 50